Locate the pressure switch. Oct 22 2016 The utterly trivial conclusion to all of this is that in order to bypass the seat safety switch in your lawn tractor all you need to do is cut the cable before the connector.
Grip the connector on the end of the wire and pull it.
How to bypass safety switch on john deere lawn mower. This will solve the. I apologize for the po. Starting the Mower with a Screwdriver.
When you are able to move the mower easily into the reverse position then the bypass of the safety switch is successful. Lower the seat on your John Deere riding mower and operate as normal. Simply unplug the pressure switch located at the right hand side of the top of the transmission.
Turn off your John Deere lawnmower remove the key from the engine and allow it to cool down before proceeding. Jul 21 2017 This safety switch can be bypassed on a riding mower with only a few tools. Finally cose the engine hood.
Lift the hood of your riding mower and disconnect the battery cables. Disconnecting or unplugging the plug will do the same as getting off the seat when the mower is running it will kill the mower because you open the switch. Look under the tractor and follow the forwardreverse linkage to the transmission.
Push the parking brake under the steering wheel on the right in to lock it. Turn on the power of the mower. There will be a plastic wire harness with wires.
Inspect the wires connected to the pressure switch. Locate the reverse safety switch near the same side as the battery on your John Deere mower. Grasp the wire harness and press down on the side tabs with your thumbs then pull them apart to unplug it.
If you want to learn about how to bypass both these safety switches on a John Deere lawnmower this article just made things a whole lot easier. 2 Push down the PTO switch on the right side of the dash to disable the. May 30 2018 Clamp the red cable to the positive battery post on the riding mower and then still wearing your rubber globes touch the other end of the red cable to the metal piece on the mowers starter.
Test the mower by lowering the mower deck and engaging the mower blade. Jun 04 2016 If you or anyone else gets hurt Im not responsible. Depending on how its wired and how many there are you may not be able to unplug the seat switch.
2 Look up under the dash of the John Deere mower beside the steering column for the RIO switch and wire. Simply cutting the cable and then insulating the exposed ends will ensure that no circuits are ever closed and therefore that all of them remain open thus mimicking the electrical behaviour of the. When the engine turns over remove the red booster cable then the black booster cable.
If you locate any disconnected wires reconnect them to the wire terminals on the switch. Sit in the operators seat of the lawn mower. Twist a wire nut over the two intertwined wires then wrap the wire nut and the ends of the wires in electrical tape to hold the wire nut in place.
Lift the hood of your mower and locate the battery. Mar 15 2021 Among the two switches one safety switch hinders the engine in case the user gets off the seat whereas the other one restricts the user from using the lawnmower in reverse if the button is not pushed. Using just a few tools the reverse safety switch on your John Deere lawn mower can be bypassed.
Jun 18 2015 Yep just unplug it then the mower wont run. I am also not responsible if you mess something up and damage your own equipment. In most cases the pressure switch looks like a metal dome and you can see where the seat presses up against the switch.
When you press reverse a pressure switch is depressed. On some lawn tractors there is an override switch installed which requires you to press a button or lever to override the safety switch and have the mower blades operate while the tractor is. Now take your position in the mower seat and place the key in the ignition switch.
Raise the hood on the mower.